Straight answers with the published price or the county rule attached to each one. Where no publisher sets a figure, the answer says what drives the price inste
Straight answers with the published price or the county rule attached to each one. Where no publisher sets a figure, the answer says what drives the price instead of inventing one.
Published figures run $754 to $1,707 for a full replacement with a $1,231 average at Angi, $1,151 to $1,869 with a $1,400 average at This Old House, and $260 to $2,300 with a $1,200 average at Forbes Home. A single eight by seven door is published at $400 to $900 and a double sixteen by seven at $650 to $3,600.
Angi publishes $65 to $85 an hour for garage door work, with two to six hours for an opener and a separate labour line of $200 to $500 on a door replacement where labour is billed apart from materials.
Angi publishes $150 to $350 per spring with a $250 average. A torsion spring alone is $75 to $150, an extension spring $50 to $100, and converting an extension system to torsion $400 to $800. Springs are replaced in pairs.
Often yes, if the panel is still made in that profile and colour. Angi publishes panel replacement at $350 to $900 with a $550 average, and up to $3,400 for a premium door. A door old enough that the profile is discontinued means a whole door.
Angi publishes $218 to $540 installed with a $379 average across 11,399 projects. The unit alone is $150 to $520, the labour two to six hours, and accessories such as a battery backup run $50 to $150 and an automatic lock $100 to $300.
Published prices put chain at $150 to $250 and belt at $160 to $350. If there is a bedroom over the garage, yes. If the garage is detached and nobody is above it, the chain drive is the cheaper answer and it lasts.
Check with Fairfax County Land Development Services on 703-222-0801 before work starts. Their published list of residential work that needs a permit includes new door openings and new or relocated electrical fixtures, and the county describes the list as general guidance rather than the code. Widening an opening or adding a circuit for an opener is the case to confirm.
Whoever holds the contract, which is the company you hire, not this site. Ask the question before you sign and get the answer in writing. A company that will not answer it is telling you something.
In most planned communities in Fairfax County, yes for the style and colour. The townhouse rows built from the 1980s onward often share one door design across a whole block. Get the approval before the door is ordered, because a door that fails design review is your cost, not the manufacturer's.
Road salt thrown off the Beltway and the Fairfax County Parkway lands on the bottom rail, and the paint film breaks there first. Add meltwater sitting in the bottom seal through February and the rail is wet and salty for weeks at a time. Rinsing the bottom section in spring is the cheapest thing you can do for a steel door.
Cold thickens the grease in the rollers and stiffens the bottom seal, and a spring that is already weak cannot compensate. A door that needs two attempts in January is usually a spring near the end of its cycle life plus dry rollers, not a failing opener.
Cycle life, not years. A door cycled four times a day reaches the same count far sooner than one cycled twice a week. A garage in this county used for storage cycles less but the springs still age, so a twenty year old door on original springs is on borrowed time in both directions.
No. A door off the track is holding its weight on a bent section of steel and a spring under tension. This is the one repair where the published saving is not worth the risk. Call a company.
Torsion springs sit on a bar above the door and last longer and fail more safely. Extension springs run along the tracks and are cheaper. Angi publishes a conversion from extension to torsion at $400 to $800, which is worth doing when the extension springs fail on a door you are keeping.
The door first if the garage is under a room, because that is the largest single surface. Published insulated doors run $1,100 to $4,200 against $754 to $1,707 for the general band. Insulating the walls of an unheated garage does less than the door does.
Compare the door model, whether tracks, cables, rollers and springs are new, whether removal and disposal are in the price, and what happens if the framing behind the opening is soft. Two quotes that differ by $400 usually differ by one of those four things.
A manufacturer warranty on the door sections, a separate one on the opener, and a labour warranty from the company. Ask for the labour term in writing and ask whether it covers the springs, since springs are the part that fails first.
Yes, and that is most of the work in this county. The constraint is space: a single eight by seven opening in a townhouse leaves little room to swing sections, so ask whether the company needs the driveway clear for the day.